Country: 104.28.25.21, North America, US

City: -122.3933 California, United States

Purchased a Dinair Pro Kit 12/06/12. Compressor failed approximately 5 months later. Customer service was fairly good and replaced with a new updated compressor. Warning, the airbrush itself does NOT have a warranty only the compressor. Compressor still works great but my airbrush stopped working and will cost $25.00 to return the airbrush for deep cleaning and repair with replacement if needed. They did offer to walk thru a cleaning by phone but that is not the problem. What appears as the problem is a seal breakdown at the tip just inside the tip cap that is causing the air brush to back bubble only. I have kept mine in wet dock between uses as instructed by Dinair videos. I can see charging $25 for cleaning but a refund of the $25 dollars would be nice if it is truley an airbrush failure.

The filament arrived promptly and was of a very high quality. I work in a robotics lab and order a large variety of filaments keeping my eye out for the best and this is toward the top of the list in the ABS category. One of the cleanest spooled filaments I've used came of the spool in perfectly layered helix's and produced beautiful prints. Never came remotely close to getting tangled on the spool like many low quality filaments can tend to do. Also have never experienced a jam using our Taz 5 printer with this filament. Build plate 110C, nozzle at 240C as well as a boxed enclosure to raise the ambient temp produced warp free large prints.

Be warned, this products shipped straight from China! So it takes a month to get to your house and you'll never know when it actually comes or if it's even real! Something they don't post in the product description